170
APPX
Appendix 3 Buffer Memory Areas
A/D conversion enable/disable setting [Q compatible mode]
When the Q compatible mode function is used, set whether to enable or disable the A/D conversion.
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is A/D conversion disabled (1).
CH1 Averaging process specification
Select processing to be performed among the sampling processing, averaging processing, and filter processing.
Averaging processing consists of time average, count average, and moving average.
If a value other than the above is set, an averaging process specification setting range error (error code: 191H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
•CH Averaging process specification
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Sampling processing (0) for all channels.
(1) 0: A/D conversion enabled, 1: A/D conversion disabled
(2) b8 to b15 are fixed to 0.
Buffer memory name CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8
A/D conversion enable/disable setting (in Q
compatible mode)
0
Setting value Setting content
0 Sampling processing
1 Time average
2 Count average
3 Moving average
4 Primary delay filter
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14 CH15 CH16
501 701 901 1101 1301 1501 1701 1901 2101 2301 2501 2701 2901 3101 3301 3501
CH1CH2CH3CH4CH5CH6CH7CH8CH1CH2CH3CH4CH5CH6CH7CH8
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b0b1b2b3b4
(1)(2)
To Next Page
Loading...
