216
APPX
Appendix 5 Operation Examples of When the Remote Head Module Is Mounted
Program example 3
The following figure shows an example of the program to perform operations reacting to an alert if an alert (process alarm
upper/lower limit) occurs in CH3.
Program example 4
The following figure shows an example of the program to perform operations reacting to an alert if an alert (rate alarm upper/
lower limit) occurs in CH1.
Program example 5
The following figure shows an example of the program to clear Input signal error detection flag, Error flag, and Latest error
code if an input signal error is detected in CH1 or an error occurs in any of the channels.
(94) Performs a processing of when an alert (process alarm upper limit) has occurred in CH3.
(113) Performs a processing of when an alert (process alarm lower limit) has occurred in CH3.
(118) Performs a processing of when an alert (rate alarm upper limit) has occurred in CH1.
(136) Performs a processing of when an alert (rate alarm lower limit) has occurred in CH1.
(141) Performs a processing of when an input signal error was detected in CH1.
(156) Turns on 'Error clear request' (Y100F).
(171) Turns off 'Error clear request' (Y100F).
To Next Page
Loading...
