7 PROCEDURES BEFORE OPERATION
229
7
Procedure on the remote head module side
1. Powering on the system
Check the following items and then power on the system.
• The power supply is wired correctly.
• The power supply voltage satisfies the specifications.
• The remote head module is in STOP state.
2. Creating a project
Start the engineering tool and create a project. ( Page 250 Creating a new project (remote head module side))
3. Connecting the personal computer and remote head module
Connect the personal computer with the engineering tool installed, and the remote head module. ( MELSEC iQ-R CC-Link
IE Field Network Remote Head Module User's Manual (Startup))
4. Initializing the remote head module
Use the engineering tool to initialize the remote head module. ( MELSEC iQ-R CC-Link IE Field Network Remote Head
Module User's Manual (Startup))
5. Setting parameters on the remote head module side
Set the system parameters, CPU parameters, and module parameters of each module.
• System parameter and CPU parameter setting (Page 250 Creating a new project (remote head module side), Page
250 Setting parameters on the remote head module side)
• Module parameter setting of each module (Page 250 Setting parameters on the remote head module side)
6. Writing to the remote head module
Write the configured parameters to the remote head module using the engineering tool. ( MELSEC iQ-R CC-Link IE Field
Network Remote Head Module User's Manual (Startup))
7. Resetting the remote head module
Use either of the following methods to restart the system on the remote head module side.
• Turning off and on the power
• Resetting the remote head module ( MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's Manual
(Startup))
To Next Page
Loading...
