Mitsubishi Electric R60AD8-G - 9 INSTALLATION AND WIRING

8 SYSTEM CONFIGURATION
8.2 Redundant Line
239
8
(4) CC-Link IE Field Network supporting cable Use cables supporting CC-Link IE Field Network. ( MELSEC iQ-R Ethernet/CC-Link IE User's
Manual (Startup))
(5) Remote head module Use two sets of the RJ72GF15-T2 to build a redundant configuration. Note that the module has
restrictions on use in a system on the system configuration diagram. For details, refer to the
MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's Manual (Application).
(6) Module set Composed of the following modules:
• R60AD8-G (Main)
• R60AD8-G (Sub)
• R60DA8-G for diagnostics
•RY40PT5B
■Precautions
• When using the R60AD8-G in SIL2 mode, there is a restriction on the version. For details, refer to
Page 240 Firmware Version for SIL2 Mode.
• Mount the above modules on the same base. Mount the modules so that they are arranged in the
following order: R60AD8-G (Main)  R60AD8-G (Sub)  R60DA8-G for diagnostics 
RY40PT5B, starting from the right side of the remote head module.
(7) Connector/terminal block converter module for
the R60AD8-G
Use the following products.
Page 240 Connector/terminal block converter module for the R60AD8-G
(8) Connector/terminal block converter module
connection cable for the R60AD8-G
This cable is a special cable for connecting the R60AD8-G and the connector/terminal block
converter module. Use the following products.
Page 240 Connector/terminal block converter module for the R60AD8-G
(9) Connector/terminal block converter module for
the R60DA8-G for diagnostics
Use the following products.
Page 240 Connector/terminal block converter module for the R60DA8-G for diagnostics
(10) Connector/terminal block converter module
connection cable for the R60DA8-G for
diagnostics
This cable is a special cable for connecting the R60DA8-G for diagnostics and the connector/
terminal block converter module. Use the following products.
Page 240 Connector/terminal block converter module for the R60DA8-G for diagnostics
(11) Terminal module for the RY40PT5B This module is used to connect the relay switching RY40PT5B to relays. Use the following products.
Page 240 Terminal module for the RY40PT5B
(12) Terminal module connection cable for the
RY40PT5B
This cable is a special cable for connecting the RY40PT5B and the terminal module. Use the
following products.
Page 240 Terminal module for the RY40PT5B
(13) Relay Use the following products.
Page 240 Relay
No. Name Description