10 FUNCTIONS
10.11 Event History Function
293
10
List of event history data
The following table lists the events that would occur in the R60AD8-G.
*1 This event may occur when switching the SIL2 Process CPU system, but the digital operation value will be held for the time when the
input HOLD function is enabled (time set in "Safety I/O Hold Time" in "CPU Parameter").
Event
code
Event
classification
Event name Description Additional information
00150 Information Safety communication start Safety communications were started.
00151 Information Safety communication stop Safety communications were stopped.
00A00
*1
Warning Safety communication error A safety communication error was detected.
00A02
*1
Warning Response monitoring timeout with
safety communication connection
being established
A response timeout occurred while a safety
communication connection was being
established.
00A03
*1
Warning Response monitoring timeout during
safety communication refresh
A response timeout occurred during safety
communication refresh.
00A04
*1
Warning Response monitoring timeout during
safety communication error
processing
A timeout occurred during the safety
communication error response.
00A05
*1
Warning Safety communication reception
interval monitoring timeout
No response was returned within the specified
safety refresh monitoring time.
00A06
*1
Warning Safety communication receive data
delay detection
Consecutive receive data is not complete.
00A07
*1
Warning Safety communication receive data
loss detection
A loss of consecutive receive data was detected.
00A08
*1
Warning Application data error A safety communication data frame error was
detected.
00A10 Warning Safety module validation match
failure
An error was detected at the verification of safety
parameter.
00A13 Warning Disabling the safety module
(parameter error)
The system switched to the safety module
disabled state because a module parameter
error was detected.
00A14 Warning Disabling the safety module (safety-
disabled module detection)
The system switched to the safety module
disabled state because a module with the safety
module disabled was detected in the module set.
00A15 Warning Disabling the safety module
(parameter mismatch when enabling
the safety module)
The system switched to the safety module
disabled state because the parameter
information saved in the non-volatile memory
and the module parameters do not match when
enabling the safety module.
20100 Information Error release (error clear) An error clear request was executed.
To Next Page
Loading...
