1 FUNCTIONS
1.4 Preset Function
25
1
Performing the preset function using an external control signal
Perform the preset function by applying an ON voltage to the preset input terminal for external input.
No. Description
(1) Write a value into CH1 Preset value setting (Un\G0 to Un\G1) in 32-bit signed binary.
(2) On the rising edge (off and on) of the preset command (A voltage is applied to the preset input terminal), the value in CH1 Present value (Un\G2
to Un\G3) is replaced with the value in CH1 Preset value setting (Un\G0 to Un\G1). The preset function can be performed regardless of the on/off
status of CH1 Count enable command (Y4).
(3) Even though a voltage is applied to the preset input terminal while CH1 External preset request detection (X4) is on, the value in CH1 Present
value (Un\G2 to Un\G3) is not replaced with the preset value.
(4) CH1 External preset request detection (X4) is turned off by turning on CH1 External preset detection reset command (Y5).
ON
OFF
ON
OFF
ON
OFF
ON
OFF
1016665210 130 131 100 10110067
0 100
(1)
(2) (2)
(4)
(3)
toto
CH1 Count enable command
(Y4)
CH1 Preset value
(Un\G0 to Un\G1)
Preset command
(preset input terminal)
CH1 External preset
request detection
(X4)
CH1 External preset
detection reset command
(Y5)
CH1 Present value
(Un\G2 to Un\G3)
Counter input pulse
To Next Page
Loading...
