2 PARAMETER SETTINGS
2.1 Parameter Setting Procedure
39
2
2 PARAMETER SETTINGS
This chapter describes the parameter settings of the high-speed counter module. Setting parameters here eliminates the
need to program them.
2.1 Parameter Setting Procedure
1. Add the high-speed counter module to an engineering tool.
Navigation window [Parameter] [Module Information] Right-click [Add New Module]
2. The basic setting, application setting, interrupt setting, and refresh settings are included in the parameter setting. Select
one of the settings from the tree on the window shown below.
Navigation window [Parameter] [Module Information] Select the high-speed counter module [Module
Parameter]
3. Write the setting to the CPU module with an engineering tool.
[Online] [Write to PLC]
4. When the CPU module is reset or is powered off and on, the setting is reflected.
2.2 Basic Setting
Set the parameters for the basic functions of the high-speed counter module.
Item Setting range Reference
Pulse input mode
*1
• 0: 1-phase multiple of 1 (default value)
• 1: 1-phase multiple of 2
• 2: CW/CCW
• 3: 2-phase multiple of 1
• 4: 2-phase multiple of 2
• 5: 2-phase multiple of 4
Counting speed setting
*1
• 0: 10kpps (default value)
• 1: 100kpps
• 2: 200kpps
• 3: 500kpps (RD62D2 only)
• 4: 1Mpps (RD62D2 only)
• 5: 2Mpps (RD62D2 only)
• 6: 4Mpps (RD62D2 only)
• 7: 8Mpps (RD62D2 only)
Counter type
*1
• 0: Linear counter (default value)
• 1: Ring counter
To Next Page
Loading...
