Mitsubishi Electric RD62P2E - Application Setting

2 PARAMETER SETTINGS
2.3 Application Setting
41
2
2.3 Application Setting
Set the parameters for the various functions of the high-speed counter module.
*1 The item can be set only in the parameter setting. It cannot be changed from the program.
*2 The external output status (clear/hold) of the high-speed counter module for when a CPU stop error occurs can be set.
*3 If a value larger than 1Mpps is set in "Counting speed setting" when the RD62D2 is used, the unit is changed from 10ms to 1ms.
Item Setting range Reference
Counter function selection setting • 0: Count disable function (default value)
• 1: Latch counter function
• 2: Sampling counter function
• 3: Cycle pulse counter function
Page 63 CH1 Counter function selection setting
Sampling/cycle time setting 1 to 65535 (default value: 0)  10ms
*3
Page 63 CH1 Sampling/cycle time setting
Function input response time setting
*1
• 0: Response time 0ms
• 4: Response time 0.1ms (default value)
• 8: Response time 1ms
• 10: Response time 10ms

Preset input response time setting
*1
• 0: Response time 0ms
• 4: Response time 0.1ms (default value)
• 8: Response time 1ms
• 10: Response time 10ms

Pulse measurement section setting • 0: ON width (default value)
• 1: OFF width
• 2: RiseRise
•3: FallFall
Page 67 CH1 Pulse measurement section setting
PWM output cycle time setting 0 to 2147483647 (default value: 2147483647) 
0.1s
Page 67 CH1 PWM output cycle time setting
PWM output ON time setting 1 0 to 2147483647 (default value: 0)  0.1s Page 67 CH1 PWM output ON time setting 1
PWM output ON time setting 2 0 to 2147483647 (default value: 0)  0.1s Page 67 CH1 PWM output ON time setting 2
CPU error output mode setting
*1*2
• 0: Clear (default value)
• 1: Hold
