Mitsubishi Electric RD62P2E - Page 61

APPENDICES
Appendix 2 I/O Signals
59
A
CH1 Counter function selection start command
• The status of Y6 in the pulse count mode is shown.
• This signal is turned on to execute the counter function selection.
■Device number
The following table shows the device number of this output signal.
■Operation timing
The operation timing differs depending on the function used.
CH1 PWM output start command (PWM output)
• The status of Y6 in the PWM output mode is shown.
• This signal is turned on to execute the PWM output.
■Device number
The following table shows the device number of this output signal.
■Operation timing
The command is valid as long as this signal is on.
CH1 Pulse measurement start command (pulse measurement)
• The status of Y6 in pulse measurement mode is shown.
• This signal is turned on to execute the pulse measurement.
■Device number
The following table shows the device number of this output signal.
■Operation timing
The command is valid as long as this signal is on.
CH1 Coincidence signal No.2 reset command
This signal is turned on to reset CH1 Counter value coincident (point No.2) (X6).
■Device number
The following table shows the device number of this output signal.
■Operation timing
The command is valid as long as this signal is on.
Signal name CH1 CH2
CH Counter function selection start command Y6 YE
Function Timing to become valid
Latch counter function At the rising edge of the signal (turned off and on)
Sampling counter function
Count disable function While the signal is on
Cycle pulse counter function
Signal name CH1 CH2
CH PWM output start command (PWM output) Y6 YE
Signal name CH1 CH2
CH Pulse measurement start command (pulse
measurement)
Y6 YE
Signal name CH1 CH2
CH Coincidence signal No.2 reset command Y7 YF