Mitsubishi Electric RD62P2E - Details of Buffer Memory Addresses

62
APPENDICES
Appendix 3 Buffer Memory Areas
Details of buffer memory addresses
This section describes the I/O numbers (X/Y), buffer memory addresses, and external I/O terminals for CH1.
To check the I/O numbers (X/Y) for CH2, refer to the following.
Page 54 List of I/O signals
To check the buffer memory addresses for CH2, refer to the following.
Page 60 List of buffer memory addresses
CH1 Preset value setting
• A preset value is stored in this area.
• The setting range is between -2147483648 and 2147483647 (32-bit signed binary value).
■Buffer memory address
The following shows the buffer memory address of this area.
CH1 Present value
• The present counter value is stored in this area.
• The counting is reflected to this area without delay.
• The range of the stored value is between -2147483648 and 2147483647 (32-bit signed binary value).
■Buffer memory address
The following shows the buffer memory address of this area.
CH1 Coincidence output point No.1 setting
• The setting value of the coincidence output point No.1 for comparison with the present counter value is stored in this area.
• The setting range is between -2147483648 and 2147483647 (32-bit signed binary value).
■Buffer memory address
The following shows the buffer memory address of this area.
CH1 Coincidence output point No.2 setting
• The setting value of the coincidence output point No.2 for comparison with the present counter value is stored in this area.
• The setting range is between -2147483648 and 2147483647 (32-bit signed binary value).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory address name CH1 CH2
CH Preset value setting 0 to 1 32 to 33
Buffer memory address name CH1 CH2
CH Present value 2 to 3 34 to 35
Buffer memory address name CH1 CH2
CH Coincidence output point No.1 setting 4 to 5 36 to 37
Buffer memory address name CH1 CH2
CH Coincidence output point No.2 setting 6 to 7 38 to 39