Mitsubishi Electric RD62P2E - Page 74

72
APPENDICES
Appendix 4 Operation Examples of When the Remote Head Module Is Mounted
6. Set "Network Configuration Settings" of "Module Parameter" of the master/local module as shown below.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic Settings]
 [Network Configuration Settings]
7. Set "Refresh Setting" of "Module Parameter" of the master/local module as shown below.
[Navigation window]  [Parameter]  [Module Information]  [RJ71GF11-T2]  [Module Parameter]  [Basic Settings]
 [Refresh Setting]
8. Write the set parameters to the CPU module on the master station. Then reset the CPU module or power off and on the
system.
[Online]  [Write to PLC]
For parameters of the master/local module which are not described in this procedure, set default values. For
details on parameters of the master/local module, refer to the following.
 MELSEC iQ-R CC-Link IE Field Network User's Manual (Application)