Mitsubishi Electric RD62P2E - Setting in the Intelligent Device Station

APPENDICES
Appendix 4 Operation Examples of When the Remote Head Module Is Mounted
73
A
Setting in the intelligent device station
Connect the engineering tool to the remote head module of the intelligent device station and set parameters.
1. Create the project with the following settings.
[Project]  [New]
2. Set "Network Required Setting" of "CPU Parameter" of the remote head module as shown below.
[Navigation window]  [Parameter]  [RJ72GF15-T2]  [CPU Parameter]  [Network Required Setting]
3. Add the high-speed counter module with the following settings.
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]