76
APPENDICES
Appendix 4 Operation Examples of When the Remote Head Module Is Mounted
7. Set "Refresh settings" of "Module Parameter" of the high-speed counter module as shown below.
[Navigation window] [Parameter] [Module Information] [RD62P2] [Module Parameter] [Refresh settings]
8. Write the set parameters to the remote head module on the intelligent device station. Then reset the remote head
module or power off and on the system.
[Online] [Write to PLC]
For parameters of the remote head module which are not described in this procedure, set default values. For
details on parameters of the remote head module, refer to the following.
• MELSEC iQ-R CC-Link IE Field Network Remote Head Module User's Manual (Application)
To Next Page
Loading...
