10 PARAMETER SETTING
10.2 Module Parameters
353
10
Setting item
The refresh setting has the following items.
Item Reference
Refresh at the set timing. Transfer to the
CPU.
Current feed value Page 478 [Md.20] Current feed value
Machine feed value Page 479 [Md.21] Machine feed value
Feedrate Page 479 [Md.22] Feedrate
Axis error No. Page 479 [Md.23] Axis error No.
Axis warning No. Page 480 [Md.24] Axis warning No.
Valid M code Page 480 [Md.25] Valid M code
Axis operation status Page 480 [Md.26] Axis operation status
Current speed Page 481 [Md.27] Current speed
Axis feedrate Page 482 [Md.28] Axis feedrate
Speed-position switching control positioning amount Page 482 [Md.29] Speed-position switching control
positioning movement amount
External input signal Page 483 [Md.30] External input signal
Status Page 483 [Md.31] Status
Target value Page 485 [Md.32] Target value
Target speed Page 486 [Md.33] Target speed
Amount of the manual pulser driving carrying over
movement
Page 492 [Md.62] Amount of the manual pulser
driving carrying over movement
Movement amount after near-point dog ON Page 487 [Md.34] Movement amount after near-
point dog ON
Torque limit stored value/forward torque limit stored
value
Page 487 [Md.35] Torque limit stored value/forward
torque limit stored value
Special start data instruction code setting value Page 487 [Md.36] Special start data instruction code
setting value
Special start data instruction parameter setting value Page 488 [Md.37] Special start data instruction
parameter setting value
Start positioning data No. setting value Page 488 [Md.38] Start positioning data No. setting
value
In speed limit flag Page 488 [Md.39] In speed limit flag
In speed change processing flag Page 489 [Md.40] In speed change processing flag
To Next Page
Loading...
