Mitsubishi Electric SD Series - Fuse of Power Supply of Pneumatic Gripper Hand

Replace the fuses Troubleshooting and maintenance instructions
7 - 4
7.4.3 Fuse of power supply of pneumatic gripper hand
Control unit CR2D / drive unit DU2
If you see error message "H0083" replace fuse S5 (rated current: 1.6 A) in the module for installation of
the optional units.
Control unit CR3D / drive unit DU3
If you see error message "H0083" replace fuse S2 (rated current: 1.6 A) in unit R700SFT.
R001496E
Fig. 7-3: Fuse of power supply for pneumatic gripper hand (CR2D/DU2)
R001497E
Fig. 7-4: Fuse of power supply for pneumatic gripper hand (CR3D/DU3)
Fuse F5
Module for installation of
the optional units
Control unit CR2D / drive unit DU2
MITSUB IS HI
CR3D-TR52
Fuse F2
CR3D control unit /
drive unit DU3
Un
i
t
R
70
0
S
F
T