EasyManua.ls Logo

Mitsubishi Heavy Industries MDC20W-H - Troubleshooting

Mitsubishi Heavy Industries MDC20W-H
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
필터청소 방법
제품의 보관
1
3
그늘에서 완벽히 건조한 프리필터를 본체에 다시 끼워주세요.
하부 돌출부를 워주세요.
2
프리필터는 최소 2주에 한번씩은
미지근한 물로 씻어주세요.
프리필터 상부에 손을 넣어 당겨
본체에서 분리하세요.
제품을 장기간 사용하지 않을 아래 방법보관 주시.
제품을 제품 내부 수분이 빠질 정도 니다.
제품, 물통 청소한 립합.
전원 선을 정리하여 제품 후면의 보관함에 보관합니다.
비닐백 등으로 씌워니다.
건조하고 환기가 되는 보관시기 니다.
내부건조 기능을 작동하여 내부의 곰팡이 냉각기에 성애가 끼는 것을 방지합니다.
If the following problems occur to the dehumidier, the followin g soluons can be adopted.
Symptoms Possible reasons Solu�ons
Does power plu
g fall? Insert power plug into socket.
The
Is the water tank full of water? (the
water tank is full of water or is
placed at incorrect posi�on).
Drain water from the water
tank, and then install the
water tank again.
dehumidier
does not
run.
The ambient temperature is too low
or too high.
Recommend to use at 5-32 .
The
dehumidifica�on
func�on is not
eec�ve.
Is the room temperature or humidity
too low?
In dry season the
dehumidifica�on ability will
reduce.
Are
the air outlet and inlet blocked?
Clean up the objects blocking
the air outlet and inlet.
Air is not blown
out.
Is the air filter net blocked?
Clean the filter frame according to
the above “Maintenance” page.
Is the dehumidier placed
improperly so that it is inclined or
unstable.
Please place the dehumidier
in flat and smooth place.
Noise is
abnormal during
operaon.
Is the air filter net blocked?
The flowing sound of
refrigerant, which is a normal
ph
enomenon.
Connec�on of drainage pipe
becomes loose.
Fasten drainage pipe.
Water leaks
Drainage system is blocked.
Remove obstacles and
straighten out water pipe.
The ambient temperature is low, and
it is in the state wai�ng for defrost.
It is a normal phenomenon,
and the dehumidier has the
automa�c defrosng func�on.
Frosng occurs
There isou.
Clean the filter frame according to
the above “Maintenance” page.
Troubleshooting
32