Mitsubishi Heavy Industries RC-EX3D - Automatic Temp Set Back; Motion Sensor Control

−13−−12−
3
The same setting method as the
Setting in the cooling operation can be
applied to the Setting in heating.
2
Set desired time and temperature with
the
▲ ▼ buttons.
When the Set button is tapped,
contents of setting are conrmed, and
the display returns to the last previous
screen.
When the
No setting button is
tapped, “ -- min. -- °C” is displayed,
and the “Automatic temp set back” is
not performed.
1
Tap the Menu button on the TOP screen and select
Energy-saving setting
⇒
Automatic temp set back
. The
Automatic temp set back screen is displayed.
Tap
Setting in cooling when setting for the cooling operation or Setting in heating when setting for the heating operation.
The Setting in cooling operation includes the cooling, dry and auto.
The Setting in heating is for the heating operation only.
Setting time range: 20 - 120 min, at 10-min intervals
Set temp range: It can be set within the preset temp range set according to the set temp range menu.
■
Automatic temp set back
It returns to the set temperature when the set time is counted up.
Automatic temp set back
Setting in cooling
Setting in heating
Back
Select the item.
No setting
Setting in cooling
Set Back
Set the time & temp to return.
min. °C
No setting
Setting in heating
Set Back
Set the time & temp to return.
min.
°C
2
Select Enable/Disable for power control. When enable, the set temperature is corrected in incremental up to ±3.0 depending on
the amount of motion.
Tap the
Set temp in cool/heat button.
4
Select Enable/Disable for auto-off. When enable, it judges by the amount of motion that there are no human around. After one
hour, the unit will be in the "operation wait" state.
Tap the
Standby time button.
3
Use the ▲ / ▼ button to set the temperature, and tap the Set button. Temporarily set the set temperature. The
possible range is as follows:
Cooling: 25 to 35°C (1°C intervals, Factory settings: 33°C)
Heating: 10 to 20°C (1°C intervals, Factory settings: 15°C)
If the amount of motion continues to be small, set temp is changed to the set temperature, and the power of the air conditioner is
reduced. "Power control ON" will be displayed while power control is set to ON. Also, the corrected temperature will be displayed
for set temp.
■
Motion sensor control (for IUs with motion sensors)
Presence of humans and the amount of motion are detected by a motion sensor to perform various controls.
■
When the R/C is set as the sub R/C, the motion sensor control cannot be set.
1
Tap the Menu button on the TOP screen and select Energy-saving setting
⇒
Motion sensor control . The motion sensor control screen and contents of the
current setting are displayed.
PJZ012A231_EN.indd 13PJZ012A231_EN.indd 13 2023/7/24 10:49:372023/7/24 10:49:37