Mitsubishi Heavy Industries RC-EX3D - Page 14

─
12
─
■
When multiple IUs are connected to the remote control for a mixed environment consisting of FDKs with a left/right ap and IUs without a
left/right ap, enabling the 3D auto ow operation will set the models without a left/right ap to a ap position set before the 3D auto ow
operation was started.
■
Since the ap is controlled automatically in the following operation, it may differ from the display on the R/C.
∙ When the room temperature is higher than the set temp (In case of the heating operation)
∙ When the “In operation for heating standby. ” or “In operation for defrosting.” is displayed (In case of the heating operation).
Cool air is blown horizontally not to blow directly to human body.
∙ In a high humidity environment (during cooling operation)
■
When you select Auto swing while the Anti draft setting (
☞
page 33) is enabled, the ap will not swing and be set at ap position
1 .
■
Changing the left/right ap direction and 3D auto ow operation cannot be performed from the SC-SL2, SC-SL3, or SC-SL4. Also note
that 3D auto ow operation will not be disabled when you change the ap direction from the SC-SL2, SC-SL3, or SC-SL4 during a 3D
auto ow operation.
Note
• Do not manually move the aps or panel with anti draft by force. It could damage these aps and panels.
• Do not blow air downward for a long period of time during the cooling operation. Condensation may be generated and water may drip from
the side panel. (In case of Ceiling suspended type)
• For FDKs with a left/right ap, it is recommended that the ap should be set toward the right side when there is a wall on the left, or set
toward the left side when there is a wall on the right. For more information, refer to the Notes in the Individual ap control section (
☞
page
32).
• If the humidity around the IU is high, the ap position may differ from the set position in order to prevent condensation forming on the IU. In
that case, the message "During condensation prevention control." will be displayed. (
☞
page 81)
When the humidity drops, the ap returns to its original position.
Advice