─
13
─
Changing the function of the F1 or F2 switch can be performed with the F1/F2 function setting (
☞
page 66).
The following functions are set as factory settings.
You may change these settings as desired.
F1
switch …High power operation
F2
switch …Energy-saving operation
F1/F2 switch operation
You can set any of the following functions to the F1 and F2 switches.
The F1
/ F2 switches act as shortcuts; it can be much easier and faster than starting an operation from the
usual Menu
on the TOP screen.
• High power operation …
☞
page 15
• Energy-saving operation …
☞
page 16
• Silent mode control …
☞
page 69
• Home leave mode …
☞
page 49
• Favorite setting operation …
☞
page 53
• Filter sign reset …
☞
page 76
• Anti draft ON/OFF …
☞
page 14
• Auto anti draft ctl …
☞
page 71
1
Tap the Change the fan speed
button on the TOP screen.
2
When the Change the fan speed screen is displayed, tap the button
of desired fan speed.
After setting the fan speed, the display returns to the TOP screen.
■
Fan speeds which can be set vary depending on the models of IU.
■
When the
Auto is selected, the fan speed is changed automatically
depending on the capacity.
Note that
Auto is not displayed and cannot be set when SC-SL2 or SC-
SL3 is connected.
Change the fan speed
Change the fan speed
Back
OutdoorRoomR/C
Select the fan speed.
Auto
• When using a standard FDT/FDTC panel (a panel without anti draft function), set functions other than the Anti draft ON/OFF function to
the
F1 and F2 switches. F1/F2 function setting (
☞
page 66)
If anti draft is turned on (operated) during the use of a standard FDT/FDTC panel, louvers may not automatically swing, which is not a malfunction.
Advice
• If the humidity around the IU is high, the fan speed may differ from the set fan speed
in order to prevent condensation forming on the IU. In that case, the message "During
condensation prevention control." will be displayed. (
☞
page 81)
When the humidity drops, the fan speed returns to its original speed.
Advice
To Next Page
Loading...
