Mitsubishi Heavy Industries RC-EX3D - Outdoor Unit Silent Mode Timer

─
56
─
Set the period of time to operate the OU with prioritizing the quietness.
When the Outdoor unit silent mode timer setting is Enabled, the silent mode operation starts and ends everyday at
the same time until the setting is Disable.
Silent mode operation can be started from an R/C operation without using the timer.
Use Silent mode cont. (
☞
page 66) for the F1
and F2 switches.
■
Outdoor unit silent mode timer
· When the Outdoor unit silent mode timer is used, the Clock setting (
☞
page 36) must be made.
· The Outdoor unit silent mode timer can be set from the main R/C only.
· The air-conditioner cannot be operated at the maximum capacity during the silent mode operation.
Advice
1
Tap the Menu button on the TOP screen and select User setting
⇒
Administrator settings
⇒
Outdoor unit silent mode timer .
2
The Outdoor unit silent mode timer setting screen is displayed.
If it is OK that the Silent mode operation is performed at the start and
end time displayed on the screen, tap the
State button to select
“State Enable”.
■
When the
State button indicates “State Disable”, the Outdoor unit silent mode
timer is not controlled.
After changing to a desired setting, tap the Set button.
To change the start time or the end time, tap the
Change button.
3
Tap Permission or Prohibition for each item.
Run/Stop
Permission
Back
Select the item.
Prohibition
Outdoor unit silent mode timer
Set Back
State
Disable
Select the item.
End time
Change
Start time
0:00 AM
1:00 AM