Mitsubishi Heavy Industries RC-EX3D - Auto Anti Draft Ctl

─
71
─
1
Tap the Menu button on the TOP screen and select Useful functions
⇒
Auto anti draft ctl .
You can also use the F1
and F2 switches to perform this operation.
Set the auto anti draft ctl to the F1
( F2 ) switch using the Switch function to perform this operation.
■
If no IU equipped with auto anti draft ctl function is connected, a message "Invalid request." is displayed on the R/C screen.
■
Depending on how the Permission/Prohibition setting (
☞
page 55) is set, the administrator password input screen may be
displayed.
2
When two or more IUs are connected to the R/C, a list of IUs is
displayed. Tap the IU to be set.
3
Tap a desired item.
1
Flap selection
... You can set each blow outlet operation for auto anti draft ctl.
(
☞
page 72)
2
Allow to air ow volume up
... You can set Enable/Disable for allow to air ow volume up.
(
☞
page 72)
Auto anti draft ctl
You can set each blow outlet operation for auto anti draft ctl and can also enable/disable for allow to air ow volume
up.
■
When the R/C is set as the sub R/C, the auto anti draft ctl cannot be set.
IU select
Next Back
Select an IU address.