─
74
─
1
Select Enable/Disable.
■
Even if enable is selected, when the communication setting with the server is
not configured by the application, wireless interface communication will not
occur.
1
Tap the Yes button.
■
If the reset operation is performed, all the wireless interface settings will be
reset. To perform wireless interface communication again, you need to configure
the settings from the R/C and application.
1
Select WPS/ AP. The selected communication mode will be
displayed in black.
2
After you select the communication mode, tap the Set button.
∗
If you do not tap the
Set button on this screen, the
communication mode will not be set.
■
After setting using the R/C, you need to set from the application "Smart M-Air".
For information about how to install and operate "Smart M-Air", refer to the
"WF-PAC-E" manuals on the MITSUBISHI HEAVY INDUSTRIES THERMAL
SYSTEMS, LTD. website.
HP: http://www.mhi-mth.co.jp/en/products/detail/
air-conditioner_users_manual.html
■
Enable/Disable
■
WPS/AP
■
Reset
1
2
To Next Page
Loading...
