─
82
─
This is displayed in the message display area when power control of the
motion sensor control (
☞
page 27) is enabled and power control is
executed.
Also, the corrected temperature is displayed for Set temp by power
control.
■
“Power control ON” display
This does not indicate a failure; the message indicates that the unit is
controlled through a central control device.
[Operations allowed during central control]
• Filter sign reset
• Administrator settings
■
“Invalid request. Central control active.” display
When the unit is controlled through a central control device (not included), and you performed an operation other than
the followings, the message “Invalid request. Central control active.” is displayed.
Menu
Direction
Cooling
16:32
(Mon)
F1: High power F2: Energy-saving
Timer
Invalid request. Central control active.
Set temp
CENTER
This is displayed in the message display area when the auto-off control
of the motion sensor control (
☞
page 27) is enabled and the auto-off
control is executed in the “operation wait" state.
The air conditioner stops during "operation wait", and will restart
operating when people return.
■
“In auto-off mode” display
To Next Page
Loading...
