Need help?Do you have a question about the Mitsubishi MOTORS M.U.T.-III and is the answer not in the manual?
General| Brand | Mitsubishi MOTORS |
|---|---|
| Model | M.U.T.-III |
| Category | Test Equipment |
| Language | English |
Follow basic service work precautions when using M.U.T.-III for inspection and repair.
Use M.U.T.-III with an assistant while driving and ensure cables do not interfere.
Do not install unauthorized software on the M.U.T.-III PC to avoid system failure.
A communication interface for connecting ECUs and PCs, used for diagnosis and reprogramming.
Stores data for ECU reprogramming and drive recorder functions.
Used for connecting V.C.I. to vehicles with a single 16-pin diagnosis connector.
Step-by-step instructions for connecting the M.U.T.-III harnesses to the PC and vehicle.
Explains core functions like DTC readout, Data List, Actuator tests, and more.
Details functions performed when V.C.I. is connected to PC or used standalone.
Procedures for powering on, starting, and shutting down the M.U.T.-III system and PC.
Step-by-step guide on how to initiate a system select diagnosis process.
Reading and erasing Diagnostic Trouble Codes (DTCs) from the vehicle ECU.
Controls ECU output devices for forced operation or shutdown during service.
Reads DTCs using V.C.I. alone via memory card, without PC.
Guides the user through the process of calibrating the steering angle sensor.
Provides steps for calibrating the lateral G sensor.
Explains methods for recording data using V.C.I. alone or on a PC.
Details how to display, analyze, and extract recorded data files.
Outlines various procedures for ECU reprogramming via K-Line and CAN communication.
Guides data transfer from PC to memory card for V.C.I. alone reprogramming.
Details the steps for reprogramming ECUs using CAN communication.
Measures and analyzes fuel consumption for injector-type engines.
Covers measurement functions for fuel pressure, voltage, resistance, and oscilloscope.
Describes the procedure for copying ECU coding data between units.
Guides writing and retrieving vehicle Chassis No. or VIN information.
Provides guidelines for common error messages and symptoms.
Addresses common issues and solutions related to V.C.I. firmware updates.
Identifies and resolves problems encountered during ECU reprogramming.
Details electrical specifications and power supply properties of the V.C.I. unit.
Provides an alphabetical glossary of technical terms used in the manual.
To Next Page