3-190
Features and controls
3
Coming home light
N00547300100
This function turns on the headlights in the low beam setting
for about 30 seconds after the ignition switch is turned to the
“OFF” position or the operation mode is put in OFF.
1. Turn the combination headlights and dimmer switch to the
“OFF” or “AUTO” position (for vehicles equipped with
the automatic light control).
2. Turn the ignition switch to the “OFF” position or put the
operation mode in OFF. Also, if a key was used to start the
engine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition switch to the
“OFF” position or putting the operation mode in OFF, pull
the turn signal lever toward you.
4. The headlights will come on in the low beam setting for
about 30 seconds. After the headlights go off, the head-
lights can be turned on again in the low beam setting for
about 30 seconds by pulling the turn signal lever toward
you within 60 seconds of turning the ignition switch to the
“OFF” position or putting the operation mode in OFF. To
turn on the headlights again after 60 seconds of turning
the ignition switch to the “OFF” position or putting the
operation mode in OFF, repeat the process from step 1.
OTE
● While the coming home light function is operating, per-
form one of the following operations to cancel the func-
tion.
• Pull the turn signal lever toward you.
• Turn the combination headlights and dimmer switch to
the “ ” or “ ” position or put the operation mode in
ON.
• Turn the ignition switch to the “ON” position or put the
operation mode in ON.
● It is possible to modify functions as follows:
• The time that the headlights remain on can be changed.
• The coming home light function can be deactivated.
For details, consult a Mitsubishi Motors dealer.
On vehicles equipped with Mitsubishi Multi-Communica-
tion System, screen operations can be used to make the
adjustment.
Refer to the separate owner’s manual for details.
BK0150700US.book 190 ページ ２０１２年３月２２日 木曜日 午後６時４６分
To Next Page
Loading...
Need help?
General
