Mitsubishi 4g63 - Page 49

OIL PAN AND OIL PUMP
ENGINE OVERHAUL <4G63-Turbo>
11D-49
4. Using special tool Silent shaft bearing installer
(MD998705), install the rear bearing. Make sure
that the oil hole of the bearing is aligned with the
oil hole of the cylinder block.
>>C<< COUNTERBALANCE SHAFT
FRONT BEARING INSTALLATION
1. Remove the rear bearing installing portion from
the special tool Silent shaft bearing installer
(MD998705).
2. Install the guide pin of the Silent shaft bearing
installer (MD998705) in the threaded hole of the
cylinder block as shown.
3. Align the ratchet ball of the special tool with the oil
hole in the rear bearing to install the bearing of the
special tool.
4. Apply engine oil to the front bearing outer surface
and bearing hole in the cylinder.
AK300179
MD998705
MD998705(Guide pin)
AG
AK300622
AG
MD998705
AK300623
AF
Rear bearing
installing portion
MD998705
AK300178
MD998705(Guide pin)
AD
AK304592
AB
Ratchet ball
Front bearing right
Oil hole
AK300179
MD998705
MD998705(Guide pin)
AG
AK300624