13A
13A-25
Special tools (Unit: mm)
Removal procedure
Removal: Injector
• Using and and with the wire of engaged in the
groove on the injector, remove the injector.
Installation: Injection pipe and fuel pipe
• Ensure that the pipe and mounting surfaces of the connector are
flat and free from damage.
• Bring the pipe into intimate contact with mounting surfaces of the
connector evenly, and temporarily tighten it without applying an
excessive force.
• Tighten it to the specified torque after temporary tightening.
Mark Tool name and shape Part No. Application
MH062560
Removing injector
(use with MH061071)
MH061071 Removing injector
Injector extractor
adapter
Nozzle extractor
A
M8 ∞ 1.25
To Next Page
Loading...
