14-18
Radiator Assembly
• Only the type A radiator can be disassembled.
Disassembly sequence
CAUTION
• Gently handle upper tank and lower tank, since they are made of a resin that can break on impact.
• If there are two paint marks on the joint between the core and upper tank or on the joint between the core
and lower tank (which indicates that the tank retaining tabs have been crimped twice before), replace the
core with a new part.
Assembly sequence
Follow the disassembly sequence in reverse.
Service standards
Tightening torque (Unit: N·m {kgf·m})
Location Maintenance item Standard value Limit Remedy
8
Air leakage from radiator
(air pressure: 177 kPa {1.8 kgf/cm
2
})
0 cm
3
{0 mL} – Repair or replace
Mark Parts to be tightened Tightening torque Remarks
Drain cock 2 {0.2} –
Bolt (side member mounting) 13 {1.3} –
1 Radiator shroud
2 Drain cock
3 Side member
4 Upper tank
5 Packing
6 Lower tank
7 Packing
8 Core
: Non-reusable parts
RADIATOR, OIL COOLER, INTERCOOLER AND FAN SHROUD
To Next Page
Loading...
