15
15-15
Installation procedure
Installation: Intake manifold
• Clean the sealing surfaces of the intake manifold and cylinder
head where they are to be mated with each other.
• Apply an even and continuous bead of sealant onto the intake
manifold surface where the cylinder head is to be mounted.
• Install the intake manifold onto the cylinder head within 3 min-
utes following the application while taking care not to spread the
sealant beyond the application area.
CAUTION
• Do not start the engine at least for an hour after the intake
manifold has been installed.
• If the intake manifold mounting bolts are subsequently
loosened or removed, be sure to apply sealant again upon
reassembly.
To Next Page
Loading...
