Mitsubishi 6M60-TL - Mold Depth between Segments; Inspection: Overrunning Clutch; Assembly: Front Bearing

54-24
(6) Mold depth between segments
• If the measurement is lower than the specified limit, rectify or re-
place the armature.
• To rectify the armature, grind the illustrated portions.
• If the mold is worn as illustrated, rectify or replace the armature.
: Acceptable
X : Unacceptable
Inspection: Overrunning clutch
If the following inspections reveal any abnormality, replace the
overrunning clutch.
• Turn the shaft in direction B and check that it rotates smoothly.
• Turn the shaft in direction A and check that it locks.
Assembly procedure
Assembly: Front bearing
• Press-fit the front bearing using –A and –B.
• After the press fitting, caulk the front bearing using the claws on
–A.
CAUTION
• Avoid re-caulking previously caulked points.
#930 STARTER