61-16
Removal procedure
Removal: Compression rings
Installation procedure
Installation: Compression rings
• Install the compression rings, ensuring that their end gaps are
located as shown in the illustration.
• Install the compression rings by following the removal sequence
in reverse.
(See “ Removal: Compression rings”.)
Installation: Lock washer, compressor gear
• Install the compressor gear onto the crankshaft, ensuring that
“O” mark on the compressor gear is aligned with “O” mark on the
crankshaft.
• Insert the protrusion of the lock washer such that the “O” mark
on the compressor gear remains exposed.
• Tighten the nut to the specified torque. Bend one part at the bot-
tom of the lock washer toward the nut to prevent the nut from
loosening.
AIR COMPRESSOR <154 cm
3
{154 mL}>
To Next Page
Loading...
