11
11-19
Installation: Packing
• Apply sealant onto the peripheral surface of the packing.
• Immediately after the sealant application, install the packing to
the rocker case.
• After installing it on the rocker case, apply sealant to the top sur-
face of the packing.
• Immediately after the sealant application, install the rocker case
upper and rocker case upper gasket in place.
CAUTION
• Do not start the engine for one hour after installation.
• When removing the rocker cover after installation, never fail
to apply sealant again.
Installation: Rocker case upper gasket
• Make sure that the gasket fitting groove in the rocker case is
clear of grease and dirt. Clean if necessary.
• Before installation, make sure that the gasket is free of grease,
etc. that could cause an oil leakage.
Installation: Rocker cover gasket
• Make sure that the gasket fitting groove in the rocker cover is
clear of grease and dirt. Clean if necessary.
• Before installation, make sure that the gasket is free of grease,
etc. that could cause an oil leakage.
To Next Page
Loading...
