Mitsubishi 6M60-TL - Locking Sub-Gears; Inspection: End Play of No. 3 Idler Gear

11-26
Special tools (Unit: mm)
Work before removal
Locking sub-gears
• Before removing the No. 3 idler gear, install a locking bolt (M8 ×
1.25 mm, length 20 mm) into the dedicated hole to lock the sub-
gears.
Inspection: End play of No. 3 idler gear
• If the measurement exceeds the limit, replace the defective
part(s).
Inspection: Backlash between No. 2 and No. 3 idler gears
• If the measurement exceeds the limit, replace the defective
part(s).
Mark Tool name and shape Part No. Application
Socket wrench MH063388 Installation of cylinder head
Pin wrench arm MH063473 Assembly of No. 3 idler gear
MH061779
Removal and installation of No. 3 idler
gear bushing
Idler gear push-puller
ABC
φ 32 φ 35 φ 32
CYLINDER HEAD AND VALVE MECHANISM