11
11-27
Removal procedure
Removal: Cylinder head
• Remove the bolts (× 4).
• Progressively loosen the cylinder head bolts in the order shown
in the illustration, going over them several times, before eventu-
ally removing them.
Removal: Cylinder head gasket
CAUTION
• Be careful not to scratch the cylinder head, crankcase and
flywheel housing when removing the cylinder head gasket.
Inspection procedure
Inspection: Clearance between No. 3 idler shaft and No. 3
idler gear bushing
• If the measurement exceeds the limit, replace the bushing.
Replacement of No. 3 idler gear bushing
[Removal]
[Installation]
• Using , press in the bushing until contacts the No. 3
idler gear.
• After installation, measure the clearance again.
• If the measurement is lower than the standard value, ream the
bushing.
To Next Page
Loading...
