11-56
Special tools
Inspection before removal
Inspection: Flywheel friction surface runout when fitted
• If the measurement exceeds the limit, check if the bolts are cor-
rectly tightened as well as the crankshaft mounting surface. Cor-
rect or replace the flywheel as required.
Removal procedure
Removal: Flywheel
• To remove the flywheel, use bolts (M16 × 1.5 mm, Length 60
mm) inserted into the dedicated holes in the flywheel.
Removal: Ring gear
• Heat the ring gear evenly with a gas burner or the like until it
reaches approximately 200°C, then remove it from the flywheel.
WARNING
• You may burn yourself if you touch the heated ring gear.
Mark Tool name and shape Part No. Application
Socket wrench MH062354
Installation of flywheel
Magnet base MH062356
FLYWHEEL
To Next Page
Loading...
