11
11-57
Inspection procedure
Inspection: Flywheel
(1) Friction surface height
• If the height is less than the limit, replace the flywheel.
(2) Friction surface distortion
• If the measurement exceeds the limit, rectify or replace the fly-
wheel.
• If the ring gear is evidently defective, replace the ring gear be-
fore inspecting the friction surface for distortion.
Rectification of friction surface
• Rectify the friction surface so that its height is not below the
specified limit, and it is parallel with surface A with an error not
exceeding 0.1 mm.
To Next Page
Loading...
