31
7. Setting the functions (Main menu)
11
11
1 COLOR ADJ Adjusting the color of the image
• With this menu, the color of the source image and memorized image can be adjusted.
• This menu is also displayed by pressing COLOR ADJUST
COLOR
ADJUST
button.
BRT (Bright )
Function
Adjust the brightness of printing image.
CONT (Contrast )
Function
Adjust the contrast of printing image
COLOR
Function
Adjust the color of printing image
TINT
Function
Adjust the tint of printing image
W•B-RED ( White balance - Red )
Function
Adjust the red-subcontrast (including white) of printing image
W•B-BLUE ( White balance - Blue)
Function
Adjust the blue-subcontrast (including white) of printing image
• The each function and setting area is as follows.
display adjusting - 64 adjusting area +63
BRT Brightness Darker ............................................................. Brighter
CONT Contrast Less contrast................................................... More contrast
display adjusting - 32 adjusting area + 31
COLOR Color Light................................................................ Deep
TINT Tint Add red ........................................................... Add green
display adjusting - 16 adjusting area + 15
W•B-RED Red-subcontrast add cyan ......................................................... add red
W•B-BLUE Blue-subcontrast add yellow ...................................................... add blue
CENTER
Function
Each setting value in "COLOR ADJ" is initialized.
When CENTER is set to "ON" , the setting value of BRT, CONT,COLOR, TINT, W•B-RED and
W•B-BLUE are reset to "0".
ANALOG ADJ. (Analog Adjust )
Function Image adjustment menu of analog input signal is displayed.
When pressing RIGHT shift button , "ANALOG ADJ " menu is displayed.
To Next Page
Loading...
