32
7. Setting the functions (Main menu)
ANALOG ADJ The adjustment image of analog input signal display
• This menu is used to adjust the image of analog input signal display before storing in the memory.
• This menu is opened when pressing RIGHT
shift button on "ANALOG ADJ : PUSH [ ] ".
BRT (Bright )
Function
Adjust the brightness of printing image.
CONT (Contrast )
Function
Adjust the contrast of printing image.
COLOR
Function
Adjust the color of printing image
• The each function and setting area is as follows.
Item Adjustment -32 Adjusting area +31
BRT Brightness Darker............................................................. Brighter
CONT Contrast Less contrast .................................................. More contrast
COLOR Color Light................................................................ Deep
CENTER
Function The setting value of " COLOR ADJ " is initialized.
When this function is set to " ON " , the setting value of BRT, CONT and COLOR is reset to 0.
• When pressing the SET
SET
button after selecting " OK " on the lower position "CHANGE : OK/CANCEL",
"1.COLOR ADJ " menu is displayed.
To Next Page
Loading...
