FUEL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY
3 - 20
3. Governor
3.1 Disassembling and inspecting the governor
Sliding sleeve wear, damage:
The sleeve should slide smoothly.
Worn or damaged weights
Levers should operate
smoothly.
Spring fatigue
Worn or damaged lever contact
with sliding sleeve
Scoring
Disassembly and inspection of the governor
<Disassembly sequence>
① Tie-rod spring
② Tie-rod
③ Speed control lever
④ Spring pin
⑤ Grooved pin
⑥ Governor shaft
(Remove ⑦ to ⑪ as an assembly.)
⑦ Governor lever
⑧ Start spring
⑨ Tension lever
⑩ Governor spring
⑪ Governor spring lever
⑫ Governor case
To Next Page
Loading...
