ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY
7 - 22
(c) Push a new brush into the brush holder before
soldering the brush lead.
2.3 Reassembling the alternator
To reassembly, follows the disassembly sequence
in reverse and do the following steps.
(a) The rear bearing has an eccentric groove
around the periphery. The deepest portion of
this groove should be aligned with the lug on
the snap ring.
(b) When replacing the rear bearing, a new
bearing should be press-fitted so that the
groove on its periphery is placed to the slip
ring side.
(c) Heat the rear bracket before press-fitting the
rear bearing into the bracket.
(d) When installing the rotor into the rear bracket,
insert a wire through a small hole in the
bracket to lift the brushes. After installation,
remove the wire.
Installing a new brush
Reassembling the alternator
Rear bracket
Brush
Wire
Wire
To Next Page
Loading...
