Mitsubishi diesel engines - Removing the Electric Wiring; Draining the Coolant; Draining the Engine Oil

REMOVAL PREPARATIONS
1 - 30
1. Preparations
1.1 Removing the Electric Wiring
Remove the wiring harnesses from the following
equipment.
Before removal, attach mating tags etc. onto the
terminals to aid reassembly.
・Starter
・Switches
1.2 Draining the Coolant
Loosen the coolant drain plug on the right-hand
side face of the cylinder block to drain coolant
from the engine.
1.3 Draining the Engine Oil
Remove the engine oil drain plug from the oil
pan to drain the engine oil.
Install and tighten the drain plug to the specified
torque.
Oil pan capacity: 3.7 to 6.0 l
(1.0 to 1.6 U.S. gal)
Do not touch the engine oil which may be
extremely hot as it can cause burns.
Removing the electric wiring
Coolant drain cock
Drain plug on the oil pan
Starter
Starter
wiring
Retaining bol
t
Drain plug
34.3 to 44.1N㨯m
(3.5 to 4.5kgf㨯m)
[25.3 to 32.5 lbf㨯ft]
Drain piug
Tightening torqe: