ENGINE MAIN PARTS - DISASSEMBLY
2 - 10
2.9 Removing the idler gear
Remove the idler gear by sliding it out along the
helical teeth.
2.10 Removing the camshaft
(1) Remove the thrust plate retaining bolts.
(2) Gently pull out the camshaft, taking care not to
damage it.
When pulling out the camshaft, pay attention
to the cams as they tend to be caught by the
surrounding parts.
2.11 Removing the fuel injection pump
camshaft
(1) Remove the stopper bolt (one place).
(2) Using a copper rod or other similar tool, tap the
rear end of the fuel injection pump camshaft.
Then, pull it out to the front of the engine.
2.12 Separating the gears from the shafts (as
required)
Using a hydraulic jack, remove the camshaft
gear and the fuel injection pump camshaft gear
from the respective shafts.
Removing the idler gear
Pulling out the camshaft
Removing the pump camshaft stopper bolt
Removing the pump camshaft
To Next Page
Loading...
