Mitsubishi diesel engines - Assembling the Rocker Shaft Assembly; Installing the Rocker Shaft Assembly; Adjusting the Valve Clearance; Installing the Rocker Cover

ENGINE MAIN PARTS - REASSEMBLY
2 - 46
3.9 Assembling the rocker shaft assembly
(1) Assemble the rocker shaft components to ensure
the correct reassembly and tighten the retaining
bolt.
(2) Ensue that the rocker arms move smoothly.
3.10 Installing the rocker shaft assembly
(1) Install the valve caps.
(2) Install the rocker shaft assembly onto the
cylinder head. Tighten the mounting bolts to
the specified torque.
3.11 Adjusting the valve clearance
Refer to “1.3 Adjusting the valve clearance”
on Page 8-3.
3.12 Installing the rocker cover
(1) Ensure that the rocker cover is correctly fitted
with gasket.
(2) Tighten the rocker cover retaining bolts to the
specified torque.
Assembling the rocker shaft assembly
Installing the rocker shaft assembly
Adjusting the valve clearance
Installing the rocker cover
Retaining bolt
Tightening torque:
9.81 to 19.6 N
m
(1.0 to 2.0 kgf
m)
[7.2 to 14.5 lbf
ft]
Tightening torque:
9.81 to 12.7 N
m
(1.0 to 1.3 kgf
m)
[7.2 to 9.4 lbf
ft]