GENERAL
Maintenance Service
Drain
Oil pan side
Engine
Engine (Turbo) and
TSB Revision
Engine (Non-turbo)>
1. Pull or push at the mid point of the belt with a force
of 98 (22 Ibs.) to measure dirve belt deflection.
Standard value: mm in.)
2. Use a tension gauge to measure belt
Standard value:
9. ENGINE OIL (Change)
Use the specified oil. (Refer to
Caution
Never use nondetergent or straight mineral oil.
1. After warming up the engine, remove the oil filler cap.
2.
Remove the drain plug to allow the engine oil to drain.
3.
Replace the drain plug gasket with a new one and tighten,
the drain plug.
4. Supply new engine oil through the oil filler.
Engine oil total quantity:
[including oil filter and oil cooler]
En
ine (Non-turbo) and
4.3 dm
(4 qts.)
En
ine (Turbo)>’
4.4 dm (4.6 qts.)
Start and run the engine a few
Stop the engine and check the level is within
the level range indicated on the oil dipstick.
5.
6.
To Next Page
Loading...
