Maintenance Service
Engine (Non-turbo)>
Engine (Turbo) and
Engine>
10. ENGINE OIL FILTER (Replace)
The quality of replacement filters varies considerably.
high quality filters should be used to assure efficient
service.
Genuine oil filters are capable of a pressure,
of 1,765 (256 psi). These high’ quality filters are highly
recommended. The followings part are available as follows.
Oil Filter Part No.
Engine (Turbo) and
Mitsubishi Genuine Parts:
35737, 36466, or
Engine (Non-turbo)>:
Chrysler Genuine Parts:
or
ENGINE OIL FILTER SELECTION
This vehicle is equipped with a oil
The same type of replacement filter is recommended a
replacement filter for this vehicle. It is possible,
in cold weather, that this vehicle may develop high
for a short duration. You should be sure that
replacement
filter used on this vehicle is a high-quality filter
and is
of withstanding a pressure of 1,765, (256
(manufacturer’s specifications) to avoid filter and engine
damage.
The following is a high-quality filter and is strongly
recommended for use on this vehicle.
Engine (Turbo) and
Mitsubishi Engine Oil Part No;
or
Engine (Non-turbo)>
Chrysler Engine Oil Filter Part No.
Any replacement oil filter should be installed
with the oil filter manufacturer’s installation
(1) Remove the engine oil filler cap.
(2)
Remove the engine oil drain plug,
out
oil.
(3) Remove the engine oil filter by using the oil filter
(4)
Clean the oil filter mounting surface of the oil filter bracket.
TSB Revision
To Next Page
Loading...
