-‘Engine Assembly
COMPRESSOR
Disconnect the compressor connector and remove the
compressor from the compressor bracket the hose
attached.
NOTE
Place the removed A/C compressor in a where it will
not be a hindrance when removing ‘and installing the engine
assembly, and tie it with a cord:
Caution
Do not bend the joint the A/C hose and the
pipe by force.
ENGINE MOUNT BRACKET ASSEMBLY
REMOVAL
(1) Support the engine with a garage jack.
(2) Remove the special tool which was attached when the
transaxle assembly was removed.
(3) Hold the engine assembly with a chain block or similar
(4) Place a garage jack against the engine oil pan with a
piece of wood in between, jack up the engine so that
the weight of the engine is no longer being applied to
the engine mount bracket, and then remove the engine
mount bracket.
ENGINE ASSEMBLY REMOVAL
After checking that all cables, hoses and harness connectors,
etc., are disconnected from the engine, lift the chain block
slowly to remove the engine assembly upward from the engine
compartment.
INSTALLATION SERVICE POINTS
ENGINE ASSEMBLY INSTALLATION
Install the engine assembly while checking that the cables,
hoses, and harness connectors are not clamped.
ENGINE MOUNT BRACKET ASSEMBLY
INSTALLATION
(1) Place a garage jack against the engine oil pan with a
piece of wood in between, and install the engine mount
bracket while adjusting the position of the engine.
(2) Support the engine with the garage jack.
(3)
Remove the chain block and support the engine assembly
with the special tool.
TSB Revision
To Next Page
Loading...
