ENGINE Crankshaft pear Oil
,
BOLT PLATE BOLT
<AK>
R E M O V A L
Use the special tool to secure. the or drive plate,
and remove the bolt.
INSTALLATION SERVICE
CRANKSHAFT REAR OIL SEAL INSTALLATION
(1) Apply a small amount of engine oil to the entire inside
diameter of the oil seal lip.
(2) Tap in the oil seal as shown in the illustration.
PLATE BOLT BOLT
<M/T>
(1) Clean off all sealant, oil and other substances which are
adhering to the threaded bolts, crankshaft thread holes
and the flywheel or drive plate
(2) Apply oil to the bearing surface of the flywheel
or drive plate bolt.
(3) Apply oil to the crankshaft thread holes.
(4) Apply sealant to the threaded mounting bolts.
Specified sealant:
Stud locking 4170 or equivalent
TSB
Revision
(5) Use the special tool to secure the flywheel or
drive plate and then tighten the the speci-
fied torque.
Specified torque:
Nm
To Next Page
Loading...
