On-vehicle
4.
Lash adjuster replacement
Caution
In the cylinder ‘are
will touch the pistons when the valves are
down, so the
piston positions.
In addition, places the
by the cams cannot be the
crankshaft should be the
are not lifted.
(I) Use the special tool to push and
remove the roller rocker .
(2) Remove. the lash adjuster from the cylinder head.
(3) Install a new lash adjuster air has
been ‘bled ‘to the
(4) Use the special tool to push down the valve, and
install the roller rocker. arm.
NOTE
When installing the roller rocker first set the
pivot side of the rocker arm onto the top of the lash
adjuster, and then after pushing down the valve, set
the slipper side of the rocker arm on top of the end
of the valve
Refer to LASH ADJUSTER
TSB Revision
To Next Page
Loading...
