GENERAL How to Use Troubleshooting/Inspection
SERVICE POINTS FOR A
Remove the fuse and measure the resistance the
load side of the fuse and ground. Set the of all,
circuits which are connected this
continuity. If the resistance is almost this
time, there
Battery
is a short somewhere switches
I
If the resistance is not 0 there is ‘no
short present
time, but a momentary short has fuse
to blow.
fuse
The main causes of a short the
.
Harness being clamped by the vehicle-body
Load
switch
Damage to the ‘of the due to wear
or heat
l
Water getting into the connector or ,
Load
Human error (mistakenly shorting a circuit, etc.)
,
TSB Revision
To Next Page
Loading...
Need help?
General
