Oil level
(5) Coat engine oil to the O-ring new filter:
(6) Screw on the oil filter by hand until it touches the
of the flange and then tighten it with the filter wrench:
. . .
etc.
.
Engine (Turbo) and
For One full or 14 ,
l
For or 17
,
Engine
l
For turn or 21
(7) Add new engine oil the oil filter...
(8) Start and run engine and check for engine oil leaks.
(9) After stopping engine, check oil level and replenish as
necessary.
MANUAL’TRANSAXLE OIL
(Check oil level)
Check each component for evidence of and check
the oil level by removing filler plug. If is contaminated,
it is necessary to replace it with new
1.
With the vehicle parked at a level the filler
plug and check that the oil level.
.
2.
The level must be up to the the filler plug
hole.
3. Check that the transaxle oil is not noticeably dirty, and
that it has a suitable viscosity.
(Change oil)
1. Remove transaxle drain plug.
2. brain oil.
3. Tighten drain plug to specified torque.
Specified torque:
Engine (Non-turbo)> 30 Nm (22
Engine (Turbo) and
32 Nm (24
4.
Remove filler plug and fill with specified oil till the level
comes to the lower portion of filler plug hole.
Specified oil:
Engine (Non-turbo)>
TEXACO MTX FLUID FM
Engine (Turbo) and
S A E o r
Quantity:
2.0 (2.1 qts.)
2.3 (2.4
To Next Page
Loading...
